Water Supply And Drain Connections - NORPOLE EWCIM90S User Manual

Water Supply and Drain Connections
The water supply and drain should be ready at the point of installation. A wall
outlet directly behind the ice maker will make under-counter installation easier.
IMPORTANT:
1. All installations must be #1 accordance with local plumbing code requirements.
Professional installation is recommended.
2. Make certain that the pipes are not pinched or kinked or damaged during
installation.
3. Check for leaks after connection.
Connecting the water line:
1. Turn off main water supply.
2. A shut-off valve must be installed to the main water supply. If the water tap has
a plain piece of copper tubing, attach a 19ram O.D.
3. Connect water supply pipe to tap and water inlet valve.
4. Turn on main water supply and tap. Check for water supply connections leaks.
Tighten any connections.
Connecting the drain line:
A gravity drain system is used in this type ice maker.
NOTE: There is a drain line near the ice maker, it is the best choice to drain water
to the drain line through the drain water pipe )rovided with icemaker.
Water tap (19mm o.d.)
Water supply pipe
Nut of the water
draining hole
-Drain pipe
1. Find the floor drain near the ice maker. The distance should be less than
970mm as the length of the long drain water pipe provided with the ice maker
is about 970mm.
2. All horizontal runs of drain lines must have a fall of 2cm per meter. An air gap
will likely be required between the ice maker drain tube and the drain/waste
12