Advertisement
5. While another person holds the Left Handlebar (6) near
the Upright (3), Connect the Handgrip Pulse Wire (70)
to the Pulse Extension Wire (98). Insert the excess
wiring into the Left Handlebar.
Hold two Handlebar Bushings (66) around the rectan-
gular tube on the left side of the Upright (3). Slide the
Left Handlebar (6) onto the Handlebar Bushings and
the tube on the Upright; be careful not to damage the
the Handgrip Pulse Wire (70) or the Pulse Extension
Wire (98). Attach the Left Handlebar with two M8 x
35mm Button Bolts (24), two M8 Split Washers (54),
and two M8 Nylon Locknuts (28); be careful not to
damage the Wires as you insert the Button Bolts.
Firmly tighten the Nylon Locknuts.
Attach the Right Handlebar (5) in the same way.
6. While another person holds the Console (4) near the
Upright (3), connect Extension Wire Harness (77), the
Pulse Extension Wire (98), and the ground wires to the
corresponding wires on the Console. Insert any slack
wire up into the Console and down into the Upright.
Attach the Console (4) to the Upright (3) with four
Console Screws (57). Make sure that the wires are
not pinched.
Snap the bookrack onto the Console (4) in the location
shown.
\\
\
\
\
66
......_-
this step.
- Console
Wires
Be careful to avoid
pinching the wires
during this step.
7. Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.
6
Advertisement
