Advertisement
ASSEMBLY
Assembly
requires two people. Place all parts of the stepper in a cleared area and remove the packing mate-
rials. Do not dispose of the packing materials until assembly is completed. In addition
to the included
allen
wrenches, assembly requires an adjustable wrench _
and a rubber mallet L ................
•
As you assemble the stepper, use the drawings below to identify the small parts used in assembly. The number
in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The
second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assem-
bled for shipping.
If a part is not in the parts bag, check to see if it has been pre-assembled.
M8 Nylon
MIO Nylon
M8 Split
MIO Split
Locknut (28)-4
Locknut (27)-4
Washer (54)-4
Washer (30)-6
MIO x 48mm Button
Screw (99)-4
i _ i
,
iiJ
M10 x 75mm Button
Screw (92)-2
M8 x 35mm
Button Bolt (24)-4
M10 x 82mm Button
Bolt (26)-4
Console
Screw (57)-4
M10 x 91mm Button
Screw (63)-2
1. While another person lifts and holds the indicated end
of the Frame (1), attach the Front Stabilizer (95) to the
Frame with two MIO x 75mm Button Screws (92).
Make sure that the Front Stabilizer is turned
so the
Wheels (67) are not touching the floor.
92
95
67
4
Advertisement
