Initializing The System - NEC 1090030 - DSX Systems PHONE SuperDisp Phone BLAC Hardware Manual

Initializing the System

To initialize (cold start) the system:
- This erases all your stored programming and returns the system to its default settings.
Turn off the system.
1.
2. Press and hold the
3. When the LED on the cabinet lights blue and then goes out, release the
• The power LED will flash green, and then "flutter" blue as the system boots.
• After about 45 seconds, the LED will wink off blue continuously and the system will restart with the
default settings.
DSX-40 Hardware Manual
Resetting and Initializing the System
Reset Switch on the Main Equipment Cabinet while turning on the system power.
Figure 27: Initializing the System
Reset Switch .
2, 3
Installation ◆ 45