Mitsubishi CS-27609 Owner's Manual page 102

Troubleshooting (cont.)
Problem Possible Solution For More Information
The remote control doesn't
work.
Check that the batteries are
installed correctly.
Check that the select switch
is set to "TV".
Be sure that you are
pointing the tip of the
remote control toward the
TV from a distance of no
more than 20 feet.
See Getti_ff Ready to Use
theRemote
Control in
Chapter 1 for an explanation
of how to install batte,_ies in
the remote control.
See Remote Control Buttons
and Functions in Chapter 1,
which explains where the
select switch is located.
See GettJng Ready to :Use
the Remote Control in
Chapter 1, which contains
pointers J_orusing the remote
control.
The TV takes several
seconds to respond to button
commands.
• Use the ENTER!EXCH
button to avoid delays.
See Changfng Channels in
Chapter 3, which explains
the function of the ENTER/
EXCH button.
You can't access a channel.
• Be sure that the channel you
want to view is programmed
into memory.
• Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See Memorizing Channels in
Chapter 3, which explains
how to p::ogram channels
into the 'iW's memory.
See Selecting the Input
Source in Chapter 3, which
explains how to change the
input source.
On-screen displays appear
each time you adjust a
function.
• This is part of the normal
operation of the TV.
See Screen Displays in
Chapter 4 for a full explana-
tion of' the on-screen dis-
plays.
100 Chapter 5: Troubleshooting