INSTALLATION
INSTRUCTIONS
Gather the required tools and parts before starting installation.
Read and follow the safety instructions
provided with any tools
listed here.
•
Flat-blade screwdriver
•
Wire stripper (direct wire
•
#2 Phillips screwdriver
installations)
•
Adjustable wrench that
•
Level
opens to 1" (2.5 cm) or
•
Vent clamps
hex-head socket wrench
(for adjusting dryer feet)
•
Caulking gun and
compound (for installing
•
1/4"nut driver
new exhaust vent)
(recommended)
•
Tin snips (new vent
installations)
Parts supplied
Remove parts packages from dryer drum. Check that all parts are
included.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements"
and "Venting Requirements"
before purchasing parts.
•
For close-clearance
installations between 31.5" (80.01 cm)
and 37" (93.98 cm), see "Plan Vent System" section for
venting requirements.
I_-
37"
--_1
(93_98
cm)
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section of this manual.
Pedestal
Are you placing the dryer on a pedestal? You may purchase a
pedestal separately for this dryer. This pedestal will add about
13" (33 cm) to the height of your unit for a total height of
approximately
51" (130 cm).
For a garage installation, you will need to place the pedestal at
least 6" (15.2 cm) above the floor.
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number LAB2700PMT (Meteorite) or LAB2700MQ0
(White).
Stack Kit
Are you planning to stack your washer and dryer? To do so, you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number 8541503.