Setting Oven Controls - Kenmore ELITE 790.4661 Series Use & Care Manual

Setting Oven Controls
Setting the Clock
The CLOCK (_ pad is used to set the dock, The dock may be set for 12 or 24 hour
time of day operation, The dock has been preset at the factory for the 12 hour operation,
When the range is first plugged in, or when the power supply to the range has been
interrupted, the display wHIflash with "PF" (power failure, See Figure 1),
When PF appears in the display, press _. No sound wHI be heard, but after 10 seconds
a beep wHI sounds and PF wHIdisappear,
INSTRUCTIONS
To set the clock (e×ample below for 1:30)
1,
Press@, "CLO" wHlappear in the display (Figure 2),
2,
Press (,_1_ (_.3j) (_ pads to set the time of day to 1:30
"CLO" wHI stay in the display, Press _. "CLO" (Figure 3),
wHIdisappear and the clock will start (Figure 8),
Changing between 12 or 24 hour time of day display
1, Press and hold _,
"CLO" will appear in the display (Figure
3), After 3 seconds lel will appear in the display indicating that
the cooktop lockout is active (Figure 4), CONTINUE holding the
pad until "12Hr" (Figure 5) or "24HP' (Figure 6) appears in the
display,
2, Press _
to switch between the 12 and 24 hour time of day
display, The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure6),
3, Press _Am_) to accept the desired change or press _ to
reject the change (Figure 7),
4, Press and hold _
until I_1disappears to cancel the cooktop
lockout feature if desired (Figure 8),
5, Reset the correct time as described in To set the Clock above,
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours,
PRESS
Q
d)Qdb
Q
for 7 seconds
Q
Q
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
17