Stitch - Kenmore 385.17124 Owner's Manual

Zipper Sewing (Continued)
To Sew:
1_ Zipper teeth
Zipper tape
Wrong side of fabric
[] Fold back the left seam allowance. Turn under
the right seam allowance to form a 0.2 to 0.3 cm
(1/8") fold. Place the zipper teeth _ next to this
fold and pin in place.
[] Attach the zipper foot with the pin of the foot on
the right-hand side.
Lower the zipper foot on the top side at the
bottom of the zipper so that the needle pierces
the fabric next to the fold and the zipper tape _.
Sew through all layers next to the fold. Stop just
before the zipper foot reaches the slider on the
zipper tape about 5 cm (2") from the top of the
zipper.
Lower the needle slightly into the fabric, raise the
foot and remove the basting stitches along the
zipper opening.
[] (_ Slider
Right side of fabric
Open the zipper to move the slider 4_ behind
the zipper foot.
Lower the foot and stitch the remainder of the
seam, making sure the fold is even.
[] Close the zipper and spread the fabric flat with
the right side ® facing up.
[] Move the zipper foot to the left pin.
Guide the edge of the foot along the zipper teeth
(_) and stitch through the garment and zipper
tape.
[] Stop at about 5 cm (2") from the top of the zipper.
Lower the needle slightly into the fabric, raise the
foot.
Open the zipper to move the slider (_ behind the
zipper foot.
Lower the foot and stitch the remainder of the
seam, making sure the fold is even.
I
[]
f
[]
f
[]
r®
f
[]
f
[]
(1/8")
®
®
4
®
4O