Installation And Connection Procedures - NEC NF2300-SE41E User Manual

4.

INSTALLATION AND CONNECTION PROCEDURES

This chapter describes the procedure for the installation and connection of the additional
disk enclosure.
In general, follow the procedure shown in Section 4.1 for the installation and connection
of the additional disk enclosure.
Take care of the matters described in Chapter 1 "NOTES ON INSTALLATION AND
HANDLING OF ADDITIONAL DISK ENCLOSURE" in doing the jobs.
4.1 Installation and Connection Procedures
• Check of components in package
Check the components in the package following "Check of Components in Package".
If any component is missed, contact your sales agent.
• Connection of FC cable
Use the cable compatible with the additional disk enclosure. Insert the connector
until the latch emits a click.
Do not bend the cable forcibly.
When disconnecting the cable, be careful not to apply excessive force to it. Hold and
remove the connector pushing the latch.
• Connection of power cord
Always use the proper power cord available for the additional disk enclosure. Do not
use the power cord with it bent and under complicated cable connections.
• Set of parameters
For setting parameters including RAID level and disk assignment, use the NEC
Storage Manager or contact your maintenance service agent.
• Check of states of resources for additional disk enclosure
Before using the additional disk enclosure, check the states of resources including
power supply, adapters, and disk drives by using the NEC Storage Manager.
Do not give shock and vibration to the additional disk enclosure. Excess
shock or vibration may cause the additional disk enclosure to be defected.
While the additional disk enclosure can accept the power of 100 - 240
VAC (50/60 Hz), the power cord coming with the additional disk enclosure
can only accept 100 - 120 VAC. Use 100 VAC (50/60 Hz) when the
attached power cord is used. Using power of different voltage may cause
electric shock, smoke, and/or fire to occur.
- 15 -
CAUTION