Table of Contents
Advertisement
(6) Strongly push the ejector (the part indicated by the arrow in the figure) until the new
power supply for the disk enclosure is inserted firmly, and secure the ejector with the
screw.
When inserting the power supply for the disk enclosure into the disk
enclosure, push it as far as it will go and then secure it with the screws.
Incorrect insertion may cause a power supply failure again.
(7) When connecting the power cord to the power supply of the disk enclosure, push
down the power cord stopper toward the left, insert the power cord, and secure the
power cord by firmly fitting the power cord stopper into the receptacle of the power
cord. After that, turn on the power switch.
- 50 -
Advertisement
Table of Contents
