Table of Contents
Advertisement
(2) Connection of power cord
Insert the provided power cord or the NEC-specified power cord to the plug on the
power supply of the disk enclosure.
When connecting the power supply of the disk enclosure, push down the power cord
stopper toward the left, insert the power cord, and then secure the power cord by
firmly fitting the power cord stopper into the receptacle of the power cord.
(3) Connection of power plug
Insert the plug of the provided power cord or the NEC-specified power cord to an
AC outlet. Because the plug has an earth pin, use an AC outlet with earth terminal
for the connection as shown in the figure below.
While the additional disk enclosure can accept the power of 100 - 240
VAC (50/60 Hz), the power cord coming with the additional disk
enclosure can only accept 100 - 120 VAC. Use 100 - 120 VAC (50/60
Hz) when the attached power cord is used. Using power of different
voltage may cause electric shock, smoke, and/or fire to occur.
- 26 -
Advertisement
Table of Contents
