Installation And Connection Of Additional Disk Enclosure - NEC NF2300-SE41E User Manual

1.3

Installation and Connection of Additional Disk Enclosure

Do not use the additional disk enclosure in an area with much moisture or
water usage. If so, a fault, electrical shock, or fire may occur.
Do not use the additional disk enclosure in an area where inflammable gas
and/or combustible substance are placed. If so, fire or explosion may occur.
Do not install the additional disk enclosure in an area of much moisture or
dust. Remove dust adhering to AC outlets and the plugs of power cords, if
any. If dust remains adhering to an AC outlet and/or plug, fire may occur.
Do not concentrate power cords only to some AC outlets. If so, fire may
occur.
Do not put a heavy substance on a power cord. If so, the coating of the power
cord may be broken, fire may occur, and/or you may be electrically shocked.
Do not connect the plug of a power cord to an AC outlet with a wet hand. If
so, you may be electrically shocked.
Make sure to disconnect all power cords and FC cables before relocating the
additional disk enclosure. If not, a malfunction of the system, an electric
shock and/or fire may occur.
While the additional disk enclosure can accept the power of 100 - 240 VAC
(50/60 Hz), the power cord coming with the additional disk enclosure can only
accept 100 - 120 VAC. Use 100 - 120 VAC (50/60 Hz) when the attached
power cord is used. Using power of different voltage may cause electric
shock, smoke, and/or fire to occur.
Do not install the additional disk enclosure and the power cords in an area
with direct sunshine or near an apparatus generating heat such as a heater. If
so, a fault may occur. Further, the coating of the power cord may be melted to
cause fire or electric shock to occur.
WARNING
CAUTION
- 3 -