Table of Contents
Advertisement
After the replacing disk drive is inserted to the end securely, push down the
ejector opened upward to click for locking.
When inserting the disk drive into the disk enclosure, push it as far as it
will go and then lock the ejector.
Incorrect insertion may cause malfunction.
(5) Inserting a new disk drive allows the data recovery to be started automatically.
If the auto repair feature is set to OFF, issue a recovery instruction
from the management software in manual mode to start recovery.
Otherwise, the reduced state ("reduce" shown as the logical disk
status) remains.
Setting the auto repair feature to ON in recovery wait state does not
start recovery. The setting is enabled starting with the next
recovery.
(6) The additional disk enclosure and disk array unit operate normally during the data
recovery. At the termination of the data recovery, the SERVICE LEDs on the array
controller and additional disk enclosure go off.
- 46 -
Advertisement
Table of Contents
