Powering On/Off The Projector; Powering On The Projector - Optoma Projector with lens cover User Manual

Installation
N
OTE
When Power

mode (Standby)
is set to Eco, the
VGA and RJ45
will be deacti-
vated when the
projector is in
standby.
N
OTE
Turn on the

projector fi rst and
then select the
signal sources.
4
English

Powering On/Off the Projector

Powering On the Projector

. Securely connect the power cord. Power on the switch  and the
Power LED fl ashes Red.
2. Turn on the lamp by pressing
projector or on the remote control. The Power LED will now turn
blue. 2
The startup screen will display in approximately 0 seconds. The
fi rst time you use the projector, you will be asked to select the
preferred language and power saving mode.
3. Turn on and connect the source that you want to display on the
screen (computer, notebook, video player, etc). The projector will
detect the source automatically. If not, push menu button and go
to "OPTIONS".
Make sure that the "Source Lock" has been set to "Off".
If you connect multiple sources at the same time, press the direct

source buttons on the control panel or on the remote control to
switch between inputs.
1
" " button either on the rear of the
2