Synchronizing Data Using The Sync Cradle - Kyocera 7135 Reference Manual

Synchronizing data using the sync cradle

Synchronizing data using the sync cradle
Running your first synchronization
The first time you synchronize data, you must enter user information on both the phone and the
Palm Desktop for the 7135 Smartphone.
Important considerations
You must perform your first synchronization with a local, direct connection using the sync
cradle, rather than using a modem or the infrared port. After the first synchronization, you
can use the other methods explained in this chapter.
Do not turn the phone power on or off during synchronization.
Do not remove the phone from the sync cradle during synchronization.
If you are a Palm user, read
before you synchronize the phone.
If you are a System Administrator preparing several phones for a group of users,
see "Synchronizing data using the infrared port" on page 54
following steps.
To synchronize data the first time
1. Once you have installed the Desktop, click the
the Windows system tray.
If the icon does not appear in the system tray, open the
Start menu and select
>
7135 Smartphone
2. In the popup menu, verify that either Local Serial or Local
is checked.
USB
3. Click Setup . The Setup window appears.
4. Click the Local tab.
5. In the Serial Port field, select the port where you connected the cable. Click OK .
USB users do not need to specify a serial port.
Note:
48
"Transferring information between Palm devices" on page 63
>
Programs Palm Desktop for the
.
HotSync Manager
before performing the
icon in
Kyocera 7135 Smartphone Reference Guide
Make sure there is a
check mark beside
Local.
Then click Setup.