Kyocera 7135 Reference Manual page 146

Using Fax/Modem mode with the wireless modem
4. Tap next to
Incoming Calls
Voice
Fax, next call
Data, next call
These settings allow you to control phone functions while the phone is in Fax/Modem mode.
These settings do not affect outgoing fax/modem operations.
5. From the computer, make the connection you want to initiate.
6. Tap End to end the data or fax call, or tap
7. Tap to view the Applications screen.
8. Tap to open Fax/Modem mode.
9. Tap Settings .
This screen shows the serial communications settings between your computer and the phone.
The default settings are adequate in most situations, but you can change these settings if
necessary. Refer to your computer user guide if you need to see what the settings are for
your computer.
10. Tap Speed and select 19200 .
This setting controls the rate of communication between your computer and the modem. It does not
Note:
affect the speed at which the modem communicates with the outside world.
11. If you need to change the bit settings to match your computer requirements, tap Flags and
select one of the following:
8-N-1 8 data bits; no parity; 1 stop bit
7 data bits; 1 bit parity; 1 stop bit
7-P-1
7-N-2 7 data bits; no parity; 2 stop bits
Unless you have an unusual computer system, you will probably not have to change the Flag settings.
Note:
12. Do not change the Flow Control setting. Leave Flow Control set to Hardware.
13. Tap Done .
138
and select an option:
Fax, until off
Data, until off
and select a different application.
Kyocera 7135 Smartphone Reference Guide