Install Range Hood; Make Electrical Connection - KitchenAid KHTU705RSS1 Installation Instructions And Use & Care Manual

5. ii!y}is_ii_ige iil}!30_ii:{:!:rlii:i_i!i ! ,iil}g, liiiiiiii_i!_Ci:iOS
Rotate the blower assembly so that the exhaust collar is
facing out the back of the hood,
A, _?
t
I
A. Exhaust b lowerassembly
B, Screws
C. Exhaustcollar
6, Replace the screws holding the blower assembiy to the hood,
7, Plug the blower motor wire back into the blower motor,
8, Screw the ground wire back onto the blower motor,
Electdcam Shock Hazard
Disconnect power before servicing,
Repmace aH parts and panels before operating,
Failure to do so can resumt in death or eJectricam shock.
1, Disconnect power at the circuit breaker of fused circuit box.
2, Connect the white wire of the power supply cable with the
white lead in the range hood using a twist-on connector,
3, Connect the black wire of the power suppiy cable with the
black lead in the range hood using a twist-on connector.
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1, Remove the terminal box cover (located on back wall of hood)
from the hood, Remove the power supply cable knockout
using a flat-blade screwdriver.
Attach strain relief in power supply cable opening so that
clamping screws are inside of range hood. Tip hood back to
its bottom surface.
2, if roof or wall cap does not have a damper, attach damper to
exhaust opening on top of the range hood using 2 small
screws from hardware package.
3, Place the range hood mounting screws close to the holes in
the cabinet bottom,
4, Lift range hood into ptace while feeding wiring through strain
relief.
5. insert the screws through the clearance holes and start them
into the hood. Then, tighten screws securely.
6. Connect vent system, for either vented or recirculating, to
range hood.
7. Seal all joints with duct tape.
8. For recircutating installations, install the vent cover (not
provided) included in Recirculation Kit Part Number 4396565
in soffit or cabinet top vent opening.
Electdcam Shock Hazard
EmectdcaHy ground blower.
Connect ground wire to green ground screw in
terminam box.
Failure to do so can resumt in death or eJectdcam shock.
4, Connect the green power supply ground wire to the unused,
green ground screw.
A .........
A. Green ground screw
B, Hood wiring
C, White wires
D
'F
D. Fwist-onconnectors
E, Blackwires
F. Powersupply cable
5, Tighten strain relief screws.
6, Replace the terminal box cover.