Installing Battery; Servicing The Fuses And Relay - Exmark Quest Lawn Mower Operator's Manual

Maintenance
Voltage Percent
Reading Charge
12.6 or 100%
greater
12.4 – 12.6 75–100%
12.2 – 12.4 50–75%
12.0–12.2 25–50%
11.7–12.0 0–25%
0%
11.7 or less
4. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 35).
Figure 35
1. Negative battery post
2. Black (-) charger lead
Note: Do Not run the machine with the battery
disconnected, electrical damage may occur.
Installing the Battery
1. Position the battery in the tray with the terminal
posts toward the operating position (Figure 34).
2. Install the positive (red) battery cable to the
positive (+) battery terminal using the fasteners
removed previously
Maximum Charging
Charger Interval
Settings
No
16 volts/7
Charging
amps
Required
30 Minutes
16 volts/7
amps
1 Hour
16 volts/7
amps
2 Hours
14.4 volts/4
amps
3 Hours
14.4 volts/4
amps
6 Hours or
14.4 volts/2
More
amps
3. Red (+) charger lead
4. Positive battery post
3. Install the negative battery cable to the negative
(-) battery terminal using the fasteners removed
previously.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down (Figure 34).
Servicing the Fuses and
Relay
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check
the component/circuit for a malfunction or short.
There is also a replaceable relay/s next to the fuse.
Refer to your Parts manual for correct replacement
components.
Fuse Block:
• Main fuse: 25 amp fuse, blade-type
• Charge Circuit: 20 amp fuse, blade-type
• Auxiliary circuit: 15 amp fuse, blade-type
• Diode: TVS
1. Raise the seat to gain access to the fuse holder
(Figure 36).
1. Cover
2. Relay
3. Auxilliary–15 amp
4. Charge–20 amp
38
Figure 36
5. Main–25 amp
6. Diode
7. Briggs & Stratton unit
8. Kohler Command unit