Jenn-Air JIM158XBCX2 Use & Care Manual page 8

9. Pull t heicemaker forward t oaccess t hetopandsides o fthe
door.
10.Remove thegaskets from theinterior door p anel andset
aside.
11.Using t hefactory d rilled holes asaguide, use ascribe and
mark thedrilling l ocations ontheoverlay p anel.
12.Drill e ight 1 /s" x1/2" (3.18mm x 12.7 mm) d eep holes intothe
overlay panel.
NOTE: Donotdrill d eeper than 1/2" (12.7mm).
13.Use eight # 8x1/2" pan-head wood screws t oattach t hepanel
tothedoor.
14.Attach ahandle o fnecessary.
15.Replace thegaskets ontheinner d oorpanel.
16.Move theicemaker back intoplace under t hecounter.
2931/64,,
(73.0 cm)
1433/64'
(36.9 cm)._
A. #8 x ½" Pan-head wood screw
B. Adhesive pads
C. Custom panel
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
• %d' wrench • Flat putty knife
• 1/4"wrench • Phillips screwdriver
Hinge pin
5/16"Hex-head hinge screw
Handle screw End Cap screw
Remove Door
1. Unplug ice maker or disconnect power.
2. Remove the handle screws and handle from the top of the
door (on some models). Keep the parts together and set them
aside.
3. Remove the hinge pin from the top hinge.
4. Remove the door from the hinges and screw the top hinge pin
back into the top hinge.
5. Remove the door skin (on some models) as follows:
• Remove the two screws from the top and bottom of the
door skin.
6.
• Remove the skin and the edge protectors from the door.
Keep the parts together and set them aside.
Reverse the door end caps as follows:
• Remove the screw and end cap from the top corner.
Move it diagonally to the opposite side's bottom corner,
keeping the straight side of the end cap facing the front of
the ice maker.
Remove the screw and end cap from the bottom corner.
Move it diagonally to the opposite side's top corner,
keeping the straight side of the end cap facing the front of
the ice maker.
A B
O
D C B A
A. Top Corner Open (no end cap)
B. Beginning Top Comer End Cap
C. Beginning Bottom Corner End Cap
D. Bottom Comer Open (no end cap)
7. Place the door back into the stainless skin, keeping the edge
protectors in place. Replace the two screws in the top and
bottom.
8. Set the door aside.
Reverse Hinges
1. Unscrew and remove the top hinge. Replace the screws in
the empty hinge holes.
2. Remove the screws from the bottom of the opposite side of
the ice maker cabinet. Turn the top hinge upside down so
that the hinge pin points up. Place the hinge on the bottom
opposite side of the ice maker and tighten screws.
3. Remove the plastic hinge pin sleeve from the "old" bottom
hinge and replace it on the new bottom hinge pin.
4. Remove the "old" bottom hinge screws and hinge. Replace
the screws in the empty hinge holes.
5. Remove the screws from the top of the opposite side of the
ice maker cabinet. Turn the hinge upside down so that the
hinge pin points down. Place the hinge on the top opposite
side of the ice maker and tighten the screws.
6. Remove the top hinge pin.