Table of Contents
Advertisement
Replacing
agitator
brush
roll
Insert agitator
through belt and
place belt in belt
guide [C) oll
agitator.
Should the agitator
shield {D) become
dislodged
while
replacing the belt
or the agitator,
reposition
it as
shown noting the
placement
of its
belt guide (E).
Securing
agitator
Grasp agitator
firmly and fit it into
position by first slid-
ing end opposite
the
belt into the redan-
gular slot {F} on side
of cleaner,
Pull other side of
agitator
(G} into
place.
Turn agitate,
mak-
ing sure belt is not
pinched between
agitator and agita-
tor shield.
Replacing
bottom
plate
Reposition
bottom
plate and 4 Phillips
head screws.
Tight-
en screws seeurel,y.
The agitator brush roll
When to replace
When agitator brushes are worn, the agita-
tor should be replaced.
To check condition
of brushes, disconnect
cleaner from electrical
outlet. Move edge
of" a card across bottom
plate while turning
agitator. To maintain
cleaning effectiveness,
replace agitator if brushes do not touch
card.
What to buy
When purchasing
a new agitator,
ask For
Hoover part No. 48414132.
How to replace
Disconnect cleaner from electrical
outlet.
Discard old agitator.
Continue
following
the directions
in "The
belt" section
to reposition belt, new agitator
and bottom
plate.
Remove bottom
plate, belt and agitator
following
directions
in "The belt" section
beginning
with Fig. 3-13.
13
Advertisement
Table of Contents
