Table of Contents
Advertisement
Carpet height adjustment
The cleaning
of
carpet
and rugs
takes place at the
nozzle
{C}.
D
When
it is neces
sary to raise and
lower the nozzle
for
various
carpet
pile
heights, slide the
nozzle control knob
{D) to the desired
setting.
Handle position
E
F
For ease in sliding knob, place handle
in the
upright
position
and till deaner
reward
(E).
The nozzle will not move into the adjusted
position
until the cleaner handle is lowered
to the operating
position (F).
Settings
For maximum cleaning performance,
the fol-
lowing carpet height settings are
" recommended.
• Lowest setting:
for bare floors
and all
types of carpet
Note: If the cleaner is difficult
to push, s]ide
knob to the next higher setting.
• Higher settings:
for very deep pile carpet
where easier pushing effort is desired, while
maintaining
good cleaning performance.
Cleaning lightweight
flexible
rugs
Stand on one end
of rug and move
cleaner
toward
other
end or edge.
Before reaching
edge, push down
on handle. This will
]ift up lhc nozz}e
(front of cleaner)
and will prevent
rug from clinging
to cleaner.
Continue
to lift up nozzle so that when you have
reached the edge, it is completely off the
rug. Move cleaner back to start again, lower
nozzle, and use only forward strokes.
Edge cleaning
Special edge
groomers are pro-
vided on both sides
of the nozzle to
remove dirt in car-
pet near baseboards
and furniture.
Stair cleaning
Guide either side of
nozzle
parallel
to
edge of carpet
or
furniture.
Use the hose and powered
hand
tool (some
models} or furnil:ure
nozzle for stair clean-
ing. Clean from bottom
to lop.
When using cleaning tools, the agitator
will
continue to rotate.
CAUTION: To avoid personal injury or unnec-
essary wear to carpet, and to prevent the
cleaner from falling,
always place it at bot-
tom of stairs.
Advertisement
Table of Contents
