To Replace Belt - Kenmore Power-Mate 1162395490 Owner's Manual

TO REPLACE BELT:
1. Slide washers and brush supports onto brush
assembly.
2. Instal! new
belt over motor
drive, then over
brush sprocket.
Motor
Drive
Brush
Brush Sprocket
Brush Support
3. Snap brush
supports into place
on base, Be sure
brush supports are
not upside-down.
4. Line up front of
cover and base,
Rest cover on front
edge of base as
shown.
Base
5. Tilt cover to
back, Press cover
firmly until side tabs
snap into place,
Replace cover
screws, light bulb
and !ight cover,
14