Pet Handimate Maintenace; To Replace Belt - Kenmore 592.30413 Use & Care Manual

PET HANDIMATE MAINTENANCE
TO REPLACE BRUSHROLL
1. If a clog is present or debris is visible,
unscrew the two screws on the back
of the pet handimate to remove the
faceplate and clear any obstructions.
2. Inspect condition of brushroll. Replace
brushroll if brushes are worn down.
To remove brushroll, pull up and out
of end slots in nozzle housing. Insert
ends of brushroll into same slots to
replace.
Note : Inspect belt to ensure that it
is in good condition. If belt is
broken or cracked, replace belt
according to To Replace Belt
instructions.
3. Insert the four tabs on edge of bottom
plate into slots on fronts of the
faceplate. Pivot faceplate down and
secure with two screws.
DJ68-00514A-00.indd 17

TO REPLACE BELT

1. Remove bottom plate. See figure in To
Replace Brushroll instructions.
2. Loop one end of new belt around shaft
of pulley.
3. Loop other end of belt around
designated area for it on brushroll.
Insert brushroll into slots in nozzle
housing. See figure in To Replace
Brushroll instructions.
4. Fit Pet Handimate back together as
described in To Replace Brushroll
instructions.
17
2009.8.22 9:19:56 AM