To Remove Belt - Kenmore Power-Mate 1162395490 Owner's Manual

], Remove light
cover by pressing in
and lifting both sides
as shown.
2. Push in and turn
bulb counterctock o,
wise to remove,
3° Replace with bulb,
Bulb must not be
higher than 15 watts,
Close light cover
until it snaps in place.
T
Disconnect cleaner from electrical outlet. Check and
remove hair, string and lint buitd-up frequently in the
POWER-MATE
TM
brusbftand brush support areas. If
build-up becomes excessive, disconnect POWER-
MATE
TM
from wand and follow the steps below,
Instructions can also be found under the light cover,
TO REMOVE BELT:
!. Remove light cover
and Iight butb as
shown under "LIGHT
BULBCHANGING."
2. Unscrew the
POWER-MATE
TM
cover
screws,
3. Turn POWER.°
MATE
TM
over. To
remove cover,
insert screw-dri-
ver at cover
tabs on both
sides and t_vvist
to release tabs.
Tab
5.Carefully
insert and
twist screw°
driver at
each brush
support to
free brush
from base.
Quick
Re_ease
4. Turn POWER.°
MATE
TM
right side
up. Press handle
release pedal
and lower the
swivel. Tilt cover
forward from
back until front
snaps free.
Brush
Support
6. Remove worn
belt.
7. Slide brush
supports off to
check and clean
brush support
areas. See page
15 for picture of
complete brush
assembly.
13