Kenmore 116.34720 Owner's Manual page 17

Remove the agitator to check for string and
hair build-up.
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um, the aqitator must be cleaned every time
the belt is chanqed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Use Clean Aqitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1time/week)
-_,, Cut off any carpet
"--, pile, hair or lint
entangled around
the agitator and
remove any string
or debris located
near the end
Cap caps.
TO REPLACE BELT
Shaft
New
Belt
Cett
J Puffer
Seat left end of agitator into nozzle base.To
seat agitator end, place rounded portion of agi-
tator end cap down into slot in nozzle base.
Loop the new belt on the motor shaft.
NOTE: Use Belt #20-5275
Loop the other end of belt onto the belt
pulley on the right end of agitator.
Pull right end of agitator forward and seat it
into nozzle base
Agitator Nozzle
Case
Press firmly, checking to see that each
end is completely inserted.
Agitator
Check to see that the belt is centered on the
belt pulley and that the agitator turns freely.
Nozzle 1
Cover
\
Nozzle Cover
Retainers
Make sure the nozzle cover retainers are in
the UNLOCK position. Hook the front of the
nozzle cover on to the nozzle base and
rotate downward. Once in place, rotate the
nozzle cover retainers to the LOCK position.
17