Kenmore 116.349254 Owner's Manual page 6

CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position Remove the
wire tie from the power cord,,
Lock the power cord \
into the locking notch
base by pressing it Lockh_
into the quick release
upper cord hook as
shown,. This helps
keep the power cord
out from under the
vacuum cleaner agi-
Power
tator.
Quick
Upper Cord
Hook
Power
Cord
Lower
Cord
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.
POWER-MATE J R.®
For operation of Power-Mate Jr,,® see
separate Owner's Manual.
Power-Mate Jr,®_, !_/_/, Latch
TO INSERT POWER-MATE JR _'
Place the rear of the Power-Mate Jr _ into
the caddy_ Rotate the Power-Mate Jr *
back until it snaps into place,
TO REMOVE POWER-MATE JR. _
Lift up on the latch and rotate Power-Mate
Jr. e out of the caddy.
uick Release
Cord
Hook
1. Turn the
quick release
upper cord
hook to either
side and down
to release the
power cord,
2o Detach the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook, Be sure the power
. To reduce the risk of electric shock,
this vacuum cleaner has a polarized
plug (one blade is wider than the
other).
. The plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
technician to install the proper outlet,
Do not change the plug in any way.
cord is still locked into the locking notch of
the upper cord hook
3. Be sure the vacuum cleaner has bag
installed. See DUST BAG REPLACEMENT,
4, Plug the polarized power cord into a 120
Volt outlet located near the floor,,
5. To replace cord, turn upper hook counter-
clockwise pointing up, then wrap cord,
6
!
t
Personal Injury and Product Damage
Hazard
• DO NOT place hands or feet under
the unit at any time.
• DO NOT use outlets above coun.
ters. Damage from cord to items in
surrounding area could occur,