Pullout Freezer Drawer - Kenmore 596.75522400 Use & Care Manual

Installation
Pullout Freezer Drawer
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the top
freezer basket.
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
To Remove:
1. Pull upper basket out to full extension and lift out
to remove.
2. Pull drawer open to full extension.
3. Lift lower basket straight up and out to remove.
/4. On each side raft is a
basket cradle with two
snap attachments. To
release each cradle,
unlatch the snaps by
pushing them inward, away
from the side raft system.
Lift the cradles off of the
rails.
5. Lift top of drawer front
to unhook supports
from rail system. Lift
door front out to
re m ove.
To Install:
1. Pull both rails out to full
extension.
2. While supporting door front,
hook supports into tabs
located on inside of rail.
3. Lower door front into
final position.
4. Place the basket cradles back onto the side rails.
Align snaps with the slots on the side rails and
press each snap towards the rail until it clicks.
5. With rails pulled out to full extension, set the
basket straight down into the basket cradles.
Basket cradle
snap attachments
6. Slide upper basket into freezer. Make sure that rear
of basket hooks behind rail catch.