Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle - Kenmore 665.15882 Use & Care Manual

®
Use this cycle for pre-
rinsed or lightly-soiled
loads. This cycle
automatically adds a fill
Use main detergent
and brief pre-wash, diapeneer section.
purging the hot water line
and improving wash
results, without adding
time for water heating
periods.
Initial display time: 48 min
Rrld;RII Wash Main Rinse Rinse Final Dry Time Water
Water Wash Heated (rain) Usage
Temp. Rinse [gal/L)
Greater • • • • 48* 5.2-6.71
than t9.7-25.4
135=F
(ST"C}
Less • • • • • 44* 6.9-8.4/
than 26.1-31.8
135°F
(ST"C)
During the first fin of a cycle
1. Pressa new cycle and/or options.
2. Check the detergentdispensers. They mustbe filled properly
for the new cycle.
After the first fill of a cycle
1. Press
The display shows
awayand silverware that willno t be washed Use this rinse cycle fOrrinsing dishes, glasses,right with this cycle. D° not use detergent _
Initial display time: 10
min
Wash Main Rinse Rinse Final Dry Time Water
Wash Heated (mln) Usage
Rinse (gal/L)
• 10 1.8-2.1/
6.8-7.9
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Anytime during a cycle, press
The display shows
2.
3.
4,
5,
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completery, The light turns off after 2
minutes.
NOTE: ff your dishwasher does not need draining, the light
turns off.
Check the detergent dispensers. They must be filled properly
for the new cycle.
Close the door.
Press a new cycle and/or options,
Press START.
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
TO add it_'ns
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door,
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5 second pause.
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press CanceVDrain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
14