Control Pad Functions - Kenmore 790.79992100 Use & Care Manual

Control Pad Functions
CLEAR PAD-- Used to
clear any function
previously entered
except the time of day
and minute timer. Push
CLEAR to stop cooking,
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN.
For satisfactory use of your oven, become familiar with the various functions
of the oven as described below,
UP and DOWN ARROW PADS-- Used along with the
function pads to select oven temperature, cooking
time, stop time (when programming an automatic stop
time), time of day, clean time and minute timer,
BAKE PAD--Used to
enter the normal "_
baking mode "__ Q'_
temperature "-.... _ "_ "
Q OVEN
I P_.HEAT
LOCK
OVEN, PREHEAT & LOCK LIGHTS-- The "OVEN"
light willglow each time the oven unit turns on to
maintain the set oven temperature,,The "PREHEAT"
light will glow when the oven is first set to operate, or
if the desired temperature is reset higher than the
actual oven temperature. The "LOCK" light will flash
until the door locks when the self-clean cycle is in
use It glows constantly after the door locks,
CLOCK PAD-- Used
set the time of day,
FEATURE
INDICATOR
LIGHTS-- These
light to show which
feature is in use,
BROIL PAD_ {
Used to select "-_ O: : _D
the variable broil "_-----I_ rc_
function _
CLEAN PAD-_
Used to select the
self-cleaning
cycle,_
BAKE TIME PAD--
Used to enter' the
O , I length of the baking
'\'\i -_----_STOP TIME PAD--
Used to set the
desired stop time for
baking, Can be
used with BAKE
TIME to program a
delayed bake cycle,.
TIMER PAD--
Used to set or
cancel the minute
timer, The minute
timer does not
start or stop
cooking,
• Bake normally
o Time bake
o Broil
• Self-clean
When choosing a function, a beep will be heard each time a pad is pushed If desired, the controls can be programmed
for silent operation, Push and hold _.
After 7 seconds, the control will beep once_ This will block the controls from
sounding when a pad is pushed. To return the sound, push and hold _
again for7 seconds until 1 beep is heard.
Note; The control will return to the audible mode after a power outage
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be
programmed for any temperature from 170°F to 550°F (65°0 to 287°C)
To change the temperature to °C (Celsius) or from "C to °F (control should not be In a Bake or Clean mode):
1. Push _" "appears in the display
2.. Push and hold the Q until "HI" appears in the display
3 Push and hold _ until °F or-°C appears in the display
4 Push the _ or _ to change °F to °C or °C to °F..
5.. Push any function pad to return to normal operating mode..