Control Pad Functions; Setting The Clock - Kenmore 790.9010 Series Use And Care Manual

Control Pad Functions
Note: The appearance of your oven control may differ slightly from the one illustrated below. However, all functions are the
same.
READ ALL INSTRUCTIONS CAREFULLY BEFOREUSING THE OVEN. Detailed instructions for each function follow later in
this book. Forsatisfactory use of your oven, become familiar with the various functions of the oven as described below.
OFF/CANCEL
Used to clear any oven
mode previously
entered except the
time of day and the
minute timer. Push
clear to stop cooking.
BAKE
Used to enter the
normal baking mode
BROIL
Used to select the
broil mode
CLEAN
Used to select the
self-cleaning mode
O
UP and DOWN ARROWS CLOCK
Used to set the clock, the timer Used to set the
and the oven temperature
I
ql_ OVEN 91b _,_ o
4=, PREHEAT
o DOOR LOCKED
time of the day.
/
TIMER ON/OFF "
STOPTIME --
OVEN, PREHEAT
AND LOCKED
Indicates which
mode is in use.
COOKTIME
Used to enter the
length of the
cooking time.
Used to set or cancel
the minute timer. The
minute timer does not
start or stop cooking.
Used with BAKE, OVEN COOK
TIME, and CLEAN to program
delayed baking or delayed self-
cleaning cycle stop time.
Note: Push buttons or pads may be shaped differently.
Note: After the appliance is first plugged in, or after a power interruption, the clock must be set
to the correct time of day before the rest of the electronic control functions will operate.
The oven can be programmed for:
• Conventional baking and roasting
° Conventional Timed baking and roasting with automatic on and off times.
• Vari broiling
° Self<leaning
For a silent control panel:
When choosing a function, a beep will be heard each time a pad is pushed. If desired, the controls can be programmed for
silent operation. Push and hold STOP TIME, After 7 seconds, the control will beep once. This will block the controls from
sounding when a pad is pushed. To return the sound, push and hold STOPTIME again for 7 seconds until a beep is heard.
Note: The control will return to the audible mode after a power outage.
Setting the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash "12:00".
INSTRUCTIONS
To Set the Clock: (example 1:30)
1. Push _.The timer allows you S seconds to go to step 2.
2. Push and hold the A or v to set the time of day to
1:30. You may also push @.
Note: The time cannot be changed during any timed bake or self-clean cycle.
PRESS DISPLAY
Aorv
®
13