Installation Instructions; Electrical Requirements - Kenmore SENSOR SMART 110.62062100 Use & Care Manual

King size capacity plus electric dryer
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Flat-blade screwdriver
Safety glasses
Adjustable wrench that
Vent clamps
opens to 1 in. or hex-
head socket wrench (for
Caulking gun and
adjusting dryer feet)
compound
(for installing
new exhaust vent)
Level
Gloves
Wire stripper (direct wire
installations)
Tin snips(new
vent
installations)
#2 Phillips screwdriver
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Parts supplied:
Remove parts package from dryer drum. Check that all parts
were included.
4 leveling legs
Parts needed:
Check local codes, check existing electrical supply and venting
and see "Electrical Requirements"
and "Venting Requirements"
before purchasing
parts.
Mobile home installations require metal exhaust system hardware
available for purchase from your local Sears store or Sears
Service Center. For further information,
please call t-800-4-MY-
HOME ®(t-800-469-4663).
You will need
A location that allows for proper exhaust installation. See
"Venting Requirements."
A separate 30 amp circuit.
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
A sturdy floor to support the total weight (dryer and load) of
200 Ibs (99.7 kg).
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire dryer. (If slope is greater than 1 in. [2.5 cm], install
Extended Dryer Feet Kit, Part No. 279819.) Clothes may not
tumble properly and models with automatic sensor cycles
may not operate correctly if dryer is not level.
Do not operate your dryer at temperatures
below 45°F (7°C). At
lower temperatures,
the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
Install the dryer where it is protected from water and/or weather.
Check code requirements.
Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SENSOR SMART 110.62062100 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents