Download Print this page

Changing Cycles, Options And Modifiers; Troubleshooting - Kenmore SENSOR SMART 110.62062100 Use & Care Manual

King size capacity plus electric dryer
Hide thumbs


Table of Contents
First try the solutions suggested here and possibly avoid
the cost of a service call.
Dryer displaying
code message
"PF" (power failure), check the following:
Is the dryer connected to the power supply?
Was the dryer connected to a power supply during
installation or a power failure?
to clear display.
Was the drying cycle interrupted by a power failure?
Press START to restart the dryer.
"E" Variable (El, E2, E3) service codes:
Call for service.
Clothes are not drying satisfactorily
Check the following:
Is the lint screen clogged with lint?
Dryer will not run
Is the power cord plugged in?
Has a fuse blown, or has a circuit breaker tripped?
Was a regular fuse used? Use a time-delay fuse.
Is the dryer door firmly closed?
Was the START button firmly pressed?
Is a cycle selected?
Unusual sounds
Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a
thumping sound during the first few minutes of operation.
Lint on load
Is the lint screen clogged?
Clean lint screen. Check for air movement.
Is the exhaust vent or outside exhaust hood clogged with lint,
restricting air movement? Run the dryer for 5-10 minutes.
Hold your hand under the outside exhaust hood to check air
If you do not feel air movement,
clean exhaust
system of lint or replace exhaust vent with heavy metal or
flexible metal vent (see "Installation Instructions").
Is the exhaust vent crushed or kinked? Replace with a heavy
metal vent ("see "Installation Instructions").
Has a fuse blown, or a circuit breaker tripped? Electric dryers
use 2 household fuses or breakers. The drum may be turning
but you may not have heat.
Has an Air Dry cycle been selected? Select the right cycle for
the types of garments being dried (see "Cycles").
Is the automatic cycle ending early? The load may not be
the electronic sensor strips. Level the dryer.
Are fabric softener sheets blocking the grille? Use only one
fabric softener sheet and only use it once.
Is the dryer located in a room with temperature
45°F (7°C)?
Proper operation of dryer cycles requires temperatures above
45°F (7°0).
Was a cold rinse water used? Was the load very wet?
Expect longer drying times with items rinsed in cold water
and with items that hold moisture (cottons).
Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Is load properly sorted?
Sort lint givers (towels, chenille) from lint takers (corduroy,
synthetics). Also sort by color.
Is the load too big or too heavy?
Dry smaller loads so lint can be carried to the lint screen.
Was the load overdried?
Use correct dryer settings for load type (see "Changing
Cycles, Options and Modifiers"). Overdrying can cause
static electricity.
Was paper or tissue left in pockets?
Is pilling being mistaken for lint?
Pilling (surface fuzz) is caused by normal wear and
Stains on load or color change
Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle
when the load is cold. Do not add fabric softener sheets to a
warm load.
Were items soiled when placed in the dryer?
Items should be clean before being dried.
Were items properly sorted?
Sort light colors from dark colors. Sort colorfast items from

Hide quick links:



Table of Contents

  Related Content for Kenmore SENSOR SMART 110.62062100