Amana NFW7200TW11 Use & Care Manual page 15

ROUBLESHOOTING
Information codes may be displayed to help you better understand what is occurring with the washer.
Code
Symbol Meaning Solution
dC Unbalanced load prevented the washer from Redistribute the load, press the
Cycle
Selector
spinning, dial.
Press Power Off pad then restart the cycle. If the
L Door is unlocked when washer is running, code reappears, call for service, see below.
J5 Door is open when washer is running. Close the door tightly and restart the cycle.
If the code reappears, call for service, see below.
FL
The washer failed to loci< the door. Close the door tightly and restart the cycle.
If the code reappears, call for service, see below.
H_ Water temperature control problem. Call for service, see below.
m (Heater Control problem)
Li_ The washer has tried to fill but has not reached Call for service, see below.
the proper water level.
L0 The door will not unlock. Make sure the door is firmly closed.
Push the Power Off pad to turn off the washer, and
then turn it on using any pad. If the code reappears,
call for service, see below.
r-_:, Motor not running properly. Restart the cycle pressing the Cycle Selector dial.
i:
_ If the code reappears, call for service, see below.
_|_2i The washer is not draining. See Troubleshooting "The washer does not drain and/or sp'n ', page 13. If problem continues, call for
service, see below.
The washer has tried to fill but was unsuccessful. Make sure the water faucets are open all the way.
P
!... Check for kinked hoses.
n
!
Check inlet screens on fill hoses.
_ Problem with control. Call for service, see below.
Electric service was lost when washer was Restart the cycle by pressing the Cycle Selector
PF running, dial.
For any codes not listed above, call Customer Service at 1-800-843-0304 USA or 1-866-587-2002 Canada.
14