Connecting Audio/Video Components; Analog Connections; Audio Component Connections; Enhancing Your Audio System - JVC RX-7030VBK Instructions Manual

Enhancing your audio system
mOnly for RX-8030VBK
_u can use this receiver _ the p_-_plifier (control amplifier)
when you connect power amplifie_ to the PREOUT jacks on the
rein"using cables with RCA pin plugs (n_ supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
Left front speaker
1
RX-8030VBK Right front speaker
Power amplifier
[l
Power amplifier
[
Center speaker
SUBWOOFER
Power amplifier
Left surround Power amplifier
speaker
Surround back speakers
Left / Right
Right surround
speaker
Note:
If you connect one surround back speaker, connect the surround back
speaker to the left surround back PREOUTjack (SURR BACK L).
When connecting individual components, refer also to the manuals
supplied with them.
• Analog Connections
If your audio components have digital audio output terminal,
connecting them using the digital cords explained in "Digital
Connections" (see page 16) will give you better sound quality.
Audio COmDor]et_t cor]r]ectior]s
Use the cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio lefl jack, and the red plug to
the audio right jack.
If your audio components have a COMPU LINK jack
See also page 41 for detailed information about the connection
and the COMPU LINK remote control system.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
Turntable
To listen to the sound after connection, press PHONO.
o 1
_a _a
RX-8030VBK
Turntable
To audio output
If a ground cable is
provided for your turntable
connect the cable to the
screw marked (_) on the
rear.
Note:
This connection is for the turntable with an MM (moving-magnet) type
cartridge.
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil) type must be connected to this receiver through a
commercial head amplifier or step-up transforme_ Direct connection
may result in insufficient volume.
11