Jenn-Air JGC8645 Use & Care Manual page 9

PROBLEM SOLUTION
Surface burner fails to light. . Check to be sure phg is securely hserted hto receptade_
° Check or re-set circuit breaker. Check or repHacefuse.
° Check power suppHy.
° Check to be sure burner is correctHy rated for your kind of gas.
Check to be sure burner ports or ignition ports are not dogged.
Check to be sure ignitor is dry and cHicking. Burner wflHnot Hightif ignitor is damaged.
soiled or wet. If ignitor doesn't chick, turn control knob OFF.
° Check to be sure burner cap is correctly seated on the burner base.
Sarface bamer flame lifts , Check to be sure a pan is sitting on the grate above.
off ports. , Contact an authorized Jenn-Air servicer.
The flame is aneven, o Burner ports may be clogged.
o Flame may need to be adjusted. Contact an authorized Jenn-Air servicer.
Sarface barrier flame is , Some yellow tips on the flame are acceptable when using LP gas.
yellow in color. , Contact an authorized Jenn-Air servicer.
8