Champion C44F Owner's Manual page 9

ASSEMBLY INSTRUCTION PAGE 8
ASSEMBLY STAGE
#3
Attach Upper Pivot Arms to the Handlebar Mast
Assembly Hardware Required:
#40 Flat Washer Qty. 2
#41 Hex Head Flange Bolt Qty. 2
#43 Flat Washer Qty. 4
#44 Wave Washer Qty. 2
#45 Thin Teflon Washer Qty. 2
Assembl v Description:
A) Slide the Threaded Pivot Shaft (#42) through the pivot-boss of the Handlebar Mast (#5). Over each end of the shall slide
1-Flat Washer (#43), 1-Wave Washer (#44), and 1-Flat Washer (#43) following the orientation shown.
B) Slide the Left Pivot Arm Assemb b" (#8) over the end of the Pivot Shaft (#42). Secure the ann to the shaft using 1-Teflon
Washer (#45), 1-Flat Washer (#40), and 1-I-Iex Head Flange Bolt (#41) tbllowing the orientation shown. Note: Loose_
tighten the Flange Bolt until the Right Pivot Ann is in place.
C) Repeat the assembly ret_rence tbr attaching the Right Pivot Arm Assembly (#9) to the Pivot Shaft (#42). Secure the arm in
place using 1-Teflon Washer (#45), 1-F"latWasher (#40), and 1-I-Iex Head Flange Bolt (#41) tblk_ving the orientation
shown.
D) Fully tighten the m(mntmghardware tbr each pivot ann. Silnultaneouslytighten the mountinghardware by turning the Hex
Head Flange Brits in oplx_sitedirectkms,as referencedby the arrows.
• Assembly Stage #3 completed