Champion C44F Owner's Manual page 12

PAGE 11
ASSEMBLY INSTRUCTION
ASSEMBLY STAGE
#6
Attach Computer & Upper Mast Covers to the Handlebar Mast
Figure #2 ]
Assembly Hardware Required:
#35 Flat Washer*
#38 Button Head Allen Bolt*
#51 Truss Screw*
(*Hardware Preinsl'_ed in the Assembly Pa_s)
QU- 3 #52 Self-Threading Screw
Qty. 3 #54 Truss Screw*
QD _, 4
Qty. 6
Qty. 4
Assembly Description:
A) Slide the Rear Pivot Cover (# 13) over the end of the Computer Mounting Bracket (#12). Route the Heart Rate Cable(# 19)
and Upper Data Cable (#6) through the mounting bracket. Secure the Mounting Bracket (to the u-bracket on the back of the
Handlebar Mast Assemb b"(#5) using 3-Button Head Allen Bolts (#38) and 3-Flat Washers (#35). Assembly Note: The
mounting hardware may be preinstalled in the assembly location and not included as part of the packaged assembly hardware.
B) As retbrenced above in Figure # 2; connect the Heart Rate Cable Assembly (#19) to the receptacle cable on the back of the
computer housing. Plug the Upper Data Cable (#6) into the board mounted connector on the back of the computer. Tuck the
excess cable length into the mounting bracket and attach the Computer (#30) to the mounting bracket using 4-Truss Screws
(#54). Assembh _Note: The mounting hardware may be preinstalled in the back of the computer housing and not included in
the packaged assembly hardware.
C) Align the Upper (Front & Rear) Mast Covers (# 13 & # 14) and secure in place using 4-Truss Screws (#51 ) and
6 -Serf-Threading Screws (#52).
• Assembly Stage #6 completed