Champion C44F Owner's Manual page 8

PAGE 7 ASSEMBLY INSTRUCTION
ASSEMBLY STAGE
#2
Attach Handlebar Mast to the Main Base
I
Figure #1
Be Careful Not to Pinch Cables ]
During Assembly ]
®
[ Hardware Preinstalled in Frame I
Assembly Hardware Required:
#35 Flat Washer*
#38 Button Head Allen Bolt*
(*Hardware may be pveinstalled in the Base Assembly)
QD:. 7 #39 Spring (Lock) Washer*
Qty. 7
Qty. 7
Assembly Description:
A) Remove the preinstalled mounting hardware from the Base Assembly (#2). Slide the Shroud Boot (#7) over the Handlebar
_MastAssembly (#5). Assembly Note: For easier assembly tape the boot in place in the upper area of the mast.
B) Connect the Upper Data Cable (#6) to the Lower Data Cable Assembly (#3) as shown in Figure 1.
C) Tuck the cable lengths inside the flame tubes and slide the Handlebar Mast Assemb b"(#5) down onto the Base Assemb b"
(#2). Align the mounting holes and secure the mast assembly in place using 7-Button Head Allen Bolts (#38), 7-Spring /
Lock Washers (#39), and 7-Flat Washers (#35) as shown.
• Assembly Stage #2 completed