Champion C44F Owner's Manual page 11

ASSEMBLY INSTRUCTION PAGE 10
ASSEMBLY STAGE #5
Attach Plastic Covers
Assembly Hardware Required:
#51 Truss Screw _
#52 Self-threading Screw
(*Some Hardware Preinstalled in the Assembly Pal_s)
QD_. 4 #53 Self-threading Screw
12
Q_,. 2
Assembly Description:
A_ssemblv Notes: Before attaching covers, check all pivot / roller mounting hardware to make sure it has been tightened
properly. Most of the lower covers x_fll be already assembled. Use the draxv_ng above as reference for any unassembled
covers. Use the proper orientation or all cove_ and assembh _hardware.
A) (These covers may be preinstalled) Attach Roller Covers (#2g & 29) to the Roller Arm Assemblies using 2-Truss Screws
(#51) andl-Serf-threading Screw (#53) per side, lbllowing the orientation rel_renced above.
B) (These covers may be preinstalled) Attach Roller Arm Pivot Covers (#24 / 25) & (#26 / 27) to the Roller Arm Assemblies
using 2 -Truss Screws (#51) and 2-Self -threading Screws (#52 ) per side, lbllowing the orientation rel_renced above.
C) Attach Lower Pivot Arm Covers (#20 / 21 ) & (#22 / 23 ) to the Pivot Arm Assemblies using 2-Truss Screws (#51 ) and
2-Self-threading Screws (#52) per side, l_bllowingthe orientationrel_renced above.
• A_ssembly Stage #5 complete