Cooling Fins; Throttle Cable; Idle Speed - Honda Harmony FG100 Owner's Manual

MAINTENANCE & ADJUSTMENTS
Cooling Fin Inspection
Inspect the engine cooling fins. Clean out any dirt and
debris if the air flow is obstructed from flowing across
the cooling fins.
If it is necessary to remove the top cover for better
access to the cooling fins, follow the disassembly
steps 1 through 3 on page 23.
Throttle Cable Inspection
Verify that the throttle trigger operates smoothly,
releases properly and the throttle cable is
undamaged. If there is visible damage, or if the
throttle lever does not operate smoothly or release
properly, take your tiller to your authorized Honda
servicing dealer.
Check the freeplay at the end of the throttle lever.
Throttle Lever Freeplay:
7/8 - 1 inch (22 - 25 mm)
If adjustment is needed, use the following Throttle
Cable Adjustment procedure below.
Throttle Cable Adjustment
1. Loosen the lock nuts with a 10 mm wrench, and
move the adjuster in or out as required.
Throttle Lever Freeplay:
7/8 - 1 inch (22 - 25 mm)
2. Tighten the lock nuts and recheck throttle lever
freeptay.
Carburetor Adjustment
A tachometer is required to adjust the idle speed. If
you do not have one, take your tiller to an authorized
Honda servicing dealer to perform idle speed
adjustment.
1. Verify that the throttle lever free play is
7/8 - 1 inch (22 - 25 mm).
2. Start the engine outdoors, and allow it to warm up
to normal operating temperature.
3. Turn the throttle stop screw to obtain a stable idle,
below the speed at which the tiller tines begin to
turn.
Standard Idle Speed: 3,100 + 200 rpm
7/8 - 1 in j_
J\
(22- 25 mm)
ADJUSTER
COOLING FINS
THROTTLE
LEVER
THROTTLE
STOP
SCREW
LOCK
NUTS
24
FG100 TILLER