Honda Harmony FG100 Owner's Manual page 17

THHng mnRocky Soi_
tf you till in rocky soil and experience continual
fine area rock jams, install the tines in the rocky
soil tine configuration to help alleviate the problem.
[ NOTICE i
Experiencing continual rock jams with the tines
instafled in the regular tine configuration, may
cause transmission damage.
1. Stop the engine (see page 13).
2. Disconnect the spark plug wire (see page 22).
3. Tip the tiller forward on the carrying handlebar
as shown.
4. Remove the lock pins from the left and right
tine shafts by turning them UP [a] and pulling
them OUT [b].
5. Clean the tine shafts.
6. Wearing heavy gloves, remove the tines. Note
that the fine sets are stamped "A", "B", "C", and
"D" just inside the raised inner area of the fine set.
7. Reinstall the fine sets in the rocky soil fine
configuration. When reinstalling the tines, make
sure the fine shaft and fine hubs are clean and
free of foreign material. The tines should easily
slide onto the shaft. Do not force the tines onto
the shaft.
8. Install each lock pin through the round side of
the fine shaft hole [a], then turn it over [b] to
lock it in place.
The rocky soil fine configuration has a wider
center untilled area than the regular fine
configuration. This will require additional
passes to till the area.
RAISED
AREA
LOCK PmN
CARRYING HANDLEBAR
--I REAR VIEW
REGULAR TmNE CONRGURATmON
27/8in 31/4in 27/8in
ROCKY SOIL TIRE CONRGURATION
UNTILLED
AREA
UNTILLED
AREA
When the tines are properly mounted, the
angled portions of the fine blade should enter
the soil first, not the straight portions.
enter the soil first.