Hotpoint RB787WC2WW Owner's Manual And Installation Instructions page 33

[]
4-Wire Conduitinstallation
Rem()ve the 3 s( rews fiom tile conne(tor blo(k.
Rein(we die grounding strap tiom the connector
block middle location and the screw connecting it to
tile timne of tile range. Insert bare whes between
tile connector block terminals and movable nuts.
Tighten screws securely. Attach ground wire to the
flame of tile range.
WARNIN& Connector block is approved for
copper wire connection only. If aluminum wire
is used, see note below.
NOTE:ALUMINUM WIRING
a.
B,
[)0 not (Olllle( [ allllIlinlllll
wire to
( ollneclor
blot k.
Use copper building whe rated %i the correct
amperage and voltage 1o make three 3" copper
jumper _dres. Connect whe as per Step 6 or 7
depending on number of wires.
Splice copper _dres to ahmdnum _dring
using special ( onnector terminals designed
and UI 7appr_wed tbrjoining copper to
ahmdnum and tollow tile connector
mam_imturer's recommended pro( edure
closely.
VV/_e u sed, l ocation andenclosure ofsplices, e tc.,must
conformtogoodw/nngpractices andlocalcodes.
t'_ _Screw
Barewire
MovablenLIt'_'_
\
Flexible cable
I
Connector b lock----_,_ I
Bracket
Barewire
tips
lrat°e" inO
I_ lip <'_ Conduit
33