Hotpoint RB787WC2WW Owner's Manual And Installation Instructions page 31

[] Power Cord Strain Relief Installation
A. Rei_love the lower rear range _iring (over to
expose the (onne(tor blo(k and bra(ket.
B°
Rem()ve the knockout ring (l _!/s") l ocated on
bracket directly beh)w the connector. To remove
the knockout, use a pair of pliers/o bend the
knockout ring away flom the bracket and twist
until ring is rem{)ved.
Wiringcover
(sllown
Ground
strap
_e- Bracket
Powercord
C°
Knockout ring inbracket. Knockout r ingremoved.
Assemble the suain relief in the hole. Insert the
power cord through the suain relief and tigh/en.
Allow era)ugh slack to easily attach the cord
terminals m the connector block. If robs me
present at the end of the winged strain relief,
they can be removed fi)r bettor fit.
NOTE:Donot installthepowercordwithouta strainrelief
Thestrainreliefbracketshould be installed before
rebsta//bg therearrangewiringcover
Strainrelief bracket
(Provided w ith rangecord.
Not partof range.}
[] 3-Wire Power Cord installation
WARNING: the neutral orground
wire of the power cord must be connected to
the neutral terminal located in the center of
the connector block. Thepower leads must be
connected to the outside (brass-colored)
terminals.
Remt we ll_e 3 x_{retemfinal screws fiom the
connector blo( k. Insert screws through each power
cord terminal ring and into the connector block
until the screws engage the nms. Be certain tl_at dm
(enter wire is (onnected to [he center screw of [he
connedor blot k. Tiglnen s(rews securely.
DONOTremove ground strapconnection,
Neutral terminal
J
Powercord
Connector block
31