Hotpoint RB787WC2WW Owner's Manual And Installation Instructions page 32

Installation Instructions.
[]
Read these instructionscompletely and carefully.
4-Wire Power Cord Installation
WARNING: The n eutral wire o f
the supply circuit is connected to the neutral
terminal located in the center of the connector
block. The power leads must be connected to
the outside (brass-colored) terminals. The 4th
grounding lead must be connected to the
frame of the range with the grounding plate
and grounding screw.
A. Renlove tile 3 screws tiom tile connector block.
B°
C°
Remove tile grounding screw and strap fiom tile
connector block iniddle location and tile screw
connection to tile fiame of the range.
Insert soews through each power cord teHninal
ring and into connector block until screw
engages nut. Be certain that the center wire is
connected to the center scI'ew ofthe connectoi
block. Tighten screws securely.
D. AttaOl ground xdre to tile fiame of the range.
Before
Neutralterminal
i
GroundStrap
(grounding t o range)
After
Neutralterminal
'ra°'Uen '
Grounding t o range"
[]
3-Wire Condu# Installation
Renl(we tile 3 so'ews fi'om tile connector block.
hlsert bare wires belween the connector block
terminals and movable ntlts. Tighten so'ews
securely. Do not remove ground suap connection.
WARNING: Connector block is approved for
copper wire connection only. If aluminum wire
is used, see note below.
NOTE:ALUMINUM WIRING
A°
B°
1)O not
connect
altllilinuiil wiie to
tile
conne(TU)i
block.
U se copper buikfing wire rated for tile correct
amperage and voltage to make three 3" copper
jumper wires. ( onnect wire as per Step 6 or 7
depending on number ofxdres.
Splice copper wires to ahmlinum wMng using
special connector terminals designed and
U L-approved fi,rjoining copper to aluminum
and tbllow tile connector mamltimuner's
recommended procedure closely.
Wireused, l ocation andenclosure of splices, e tc.,must
conformtogoodwiringpractices andlocalcodes.
"__ Screw
_°n'm'i_ctior bl°ck
I
Barewire -_,-_,'*_
Movable nut'------_ _ _'_
Flexible cable
/
Bracket
32