How To Operate Your Friedrich Zstar - Friedrich ZStar ZQ08 Installation And Operation Manual

How to OperateYourZStar RoomAir Conditioner
The controls will look like the following.
Walt three minutes
before restarting
OFeF
High _ High
L°Wo\ _1 J _ /e Med
Fan " _ -Cool
Low ecool
Controls
When the air conditioner has finished cooling the room and is turned off or set to the
fan position, wait at least 3 minutes before resetting to the cooling operation again.
• FOR NORMAL COOLING
1. Turn the Mode switch to the High, Med, or Low Cool setting.
2. Set the Temperature control to the desired temperature point (the mid-point is a
good starting position). If the room temperature is not satisfactory after a
reasonable time, adjust the control to a cooler or warmer setting, as appropriate.
• FOR MAXIMUM COOLING
1. Turn the Mode switch to the High Cool setting.
2. Set the temperature control to the coolest temperature point (all the way to the
right).
• FOR QUIETER OPERATION
1. Turn the Mode switch to the Low Cool setting.
2. Set the Temperature control as needed.
• EnergySaver Switch
This rocker switch can be depressed to either YES or NO. In the yes position, you will
get the most economical operation. Both the fan and the compressor will cycle on and
off together, maintaining the selected temperature at a more constant level and
reducing the humidity more efficiently. This control will only operate when the unit is in
a cooling mode. In the NO position, the fan will run constantly as long as the unit is in
the cooling mode.