Advertisement
Cleaning
tools
When using cleaning tools, cleaner han-
dle should be in the upright position
to activate the automatic "brush
roll
OFF" and for convenience
in moving
the cleaner from one area to another.
_I_'__
F
G
_H
(
))
J
K
L
Turn cleaner OFF before disconnect-
ing and connecting hose to hose tube
(E).
To use hose, lift hose end as shown.
Select
proper
tool
F. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards,
shutters, and registers.
G. Furniture nozzle may be used for
upholstered furniture, draperies,
mat-
tresses, clothing, automobile
interiors,
and carpeted
stairs.
H. Powered hand tool may be used for
upholstered furniture, carpeted stairs
and hard-to-reach
places.
I. Crevice wand can be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs, and baseboards.
It can also be used for extra reach with
the dusting brush and/or extension
wand.
J. Wand is used to give extra length to
your hose. Use it with any of the above
tools.
Attach
wand
and tools
Attach tool or wand to the hose (K) by
pushing it firmly into hose.
Attach second wand or tool to wand (L)
by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.
How
to clean
tools
To clean the hose and the powered
hand tool, wipe off dirt with a cloth
dampened
in a mild detergent. Rinse
with a damp cloth. Do not submerge
powered hand tool in water.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
k_ I:.'1
N
Extra
reach
hose
(available
at additional
cost)
Push Custom Control
TM
switch to OFF
position.
Align end of extra reach hose with pro-
jections (M) over slots (N) on end of
attached hose.
Slide hose into slots and twist hose to
lock it in place. (To detach hose, reverse
procedure.)
Attach wands or tools to the other end of
hose.
Stair
cleaning
Use the hose and powered hand tool or
furniture nozzle for stair cleaning.
CAUTION: To prevent the cleaner
from falling, always place it at the
bottom of the stairs.
With handle in upright position, clean
from bottom to top.
How
to attach
tool
cover
The tool cover is designed with a "break-
away" feature which allows it to snap free if
it is pushed open too far.
To reattach, align hinges of cover with slots
on sides of tool storage area.
Push cover down to secure in place.
Advertisement
