Lubrication; Thermal Protector; Authorized Service - Hoover uh70085 Owner's Manual

Lubrication

The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. The
addition of lubricant could cause damage. Therefore, do not add lubricant to motor bearings.
The agitator brushroll is equipped with two ball bearings that should be lubricated periodically by a
Hoover Sales and Service Center or an Authorized Hoover Warranty Service Dealer.

Thermal Protector

An internal thermal protector has been designed into your cleaner to protect it from overheating.
When the thermal protector activates, the cleaner will stop running. If this happens, proceed as
follows:
1. Turn the cleaner OFF and disconnect it from the electrical outlet.
2. Check secondary and final filters for dirt accumulation.
3. Refer to "Clearing blockages" section.
4. When cleaner is unplugged and the motor cools for 30 minutes, the thermal protector
automatically resets and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner may need
servicing (see "Service" section).
Service
To obtain approved Hoover® service and genuine Hoover® parts, locate the nearest Authorized
Hoover® Warranty Service Dealer (Depot) by:
service center link to find the service outlet nearest you.
Do not send your cleaner to Hoover®, Inc., Company in Glenwillow for service. This will only result in delay.
If you need further assistance:
To speak with a customer service representative call1-800-263-6376; Mon-Fri 8am-7pm EST. In
Canada, contact Hoover® Canada, Toronto: 755 Progress Ave., Scarborough, ON M1H 2W7 OR Hoover®
Canada, Edmonton: 18129-111 Ave., Edmonton, AB T5W 2P2, Phone: 1-800-263-6376, Mon-Fri 8am-
7pm EST.
Always identify your cleaner by the complete model number when requesting information or ordering
parts. (The model number appears on the back of the cleaner.)
Please do not return this product to the store.
14