Advertisement
Available languages
Available languages
XQB60-91S_ Mm'_UAI_ ZO/22/OZ lZ:42 _/_qe
20
Before calling
for service,
determine
the symptoms
and follow suggested
solutions.
Washer
does
not operate:
• Check if unit is plugged
in, The plug may have come loose.
• Check if the electrical
wall receptacle
is of proper voltage,
• Check if the circuit breaker
needs to be reset or if the fuse needs to be replaced.
• Check if the washer
is overloaded:
load may need to be re-balanced
and clothes
may need to be redistributed.
• Check if the door is open, You may have to close the door properly.
• The washer
pauses in some cycles. This is normal
in synthetic
or gentle cycle,
which has short soak period
where your clothes are being soaked
for very short
period
of time. You will not hear washer
operate for a short period
of time, When
the soak time is over,
it will start automatically.
• Check if the program/option
selections are set properly.
You may have to adjust
proper
setting,
(refer to "Operation"
section)
• Check if you have selected "Delay
Start" option,
You may have to turn that option
off and reselect,
• Check the Power "On/Off"
button to see if it is on "OFF" position,
You may have
to press the button to set it on "ON"
position.
• Check if the "Start/Pause"
button
is on "Pause"
mode,
Press this button to start the
wash process.
• The wash process is paused,
This is normal.
The clothes sensor is checking
clothes to verify that there are
clothes inside the wash tub, it will add water approximately
48 seconds later,
• The Pulsator pauses during
incoming
water flow in wash and rinse cycle.
This is normal,
It is to avoid splashing
during
water inlet.
19
Advertisement
