Configuring The Network Settings - Aastra ATP-CNX-020 Installation And Setup Manual

Aastra CNX Quick Installation and Setup Guide
Procedures

Configuring the network settings

7
Configure the network settings
Requirements
The following is required before you configure the Aastra CNX for the first time:
• The Aastra CNX must physically be connected to your console using an
RS-232/DB-9 cable.
• The Aastra CNX must physically be connected to your network interface via the Ethernet
port(s).
• The Aastra CNX must be turned on.
• You must be running a terminal emulator on your PC. Terminal emulator must be set as
follows:
— Baud Rate
— Data
— Parity
— Stop
— Flow Control
The Aastra CNX setup script allows you to configure the following:
(1) Run network and time configuration
The following procedure describes how to configure the network settings.
Note: If at any time during the initial configuration process, you want to
backout of the configuration, press <ESC> to cancel.
8
9600
8 bit
None
1 bit
None
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06