Table of Contents
Advertisement
Aastra CNX Quick Installation and Setup Guide
Procedures
Connecting to the console port
3
Connect to the console
You can access the Aastra CNX console locally or remotely. Ensure that you
configure your terminal or PC (terminal emulator) console port parameters.
Local connection
To connect a local PC or terminal:
a. Attach the 9-pin male DB-9 connector on the serial cable to the
female console port on the rear panel of the Aastra CNX.
b. Attach the 9-pin female connector on the serial cable to the male console
port on the back of your PC or terminal.
Remote connection
To connect a remote PC and an Aastra CNX to an Ethernet LAN:
a. Attach one end of an Ethernet cable to the Ethernet port on the PC, and the other end to a LAN port.
b. Attach one end of an Ethernet cable to an Ethernet port on the back panel of the Aastra CNX,
and the other end to a LAN port.
To connect a modem:
a. Attach the 9-pin male connector on the serial cable to the female console port on the rear panel of the
Aastra CNX.
b. Attach a 25-pin male connector on the modem cable to the modem's DB-25 RS-232 port.
Aastra CNX
1
100-240
VAC
1.0A 47-63HZ
Console port
4
T1 / E1
10/100 ENET
2
3
4
CONSOLE
RESET
1
2
To console port
on Aastra CNX
DB-9 port on PC
Ethernet LAN
DB-9 to DB-9 console cable
DB-9 to DB-25 modem cable
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06
Console port parameters
Parameter
Value
Baud rate
9600
Flow control
None
Data bits
8
Stop bits
1
Parity
None
PC or terminal
Modem
(AT or Hayes compatible)
DB-25 RS-232 port
NMS
PHONE
DIAL
DTE
(LEASE
(LEASED)
DWR
3810
3810
Advertisement
Table of Contents
